DESIGNED AND MADE IN THE USA

USING DOMESTIC AND IMPORTED COMPONENTS

The Klipsch RF-7 III speaker is a testament to the quality that Klipsch

demands from each and every one of its audio products. Remember

great sound? We do, too. The RF-7 III enclosure is made in the USA, by

proud craftsmen in Hope, Arkansas. Just like Paul W. Klipsch (PWK)

intended.

NEW 1 3/4 TITANIUM DIAPHRAGM COMPRESSION DRIVER

The compression driver features a new phase plug design to improve

phase coherency at the throat of the horn, resulting in improved

sound pressure linearity at high frequencies.

90° x 90° TRACTRIX® HORN

The redesigned Tractrix Horn utilizes a circular horn throat paired to

a square horn mouth to further improve high-frequency response and

extension, while enhancing imaging and dynamics. The compressed

molded rubber construction adds high frequency damping to reduce

harshness and improve detail. This creates the cleanest, most natural

sound possible.

SPUN COPPER CERAMETALLIC WOOFERS™

Cerametallic woofers represent the pinnacle of Klipsch driver design,

maintaining exceptional rigidity, and lightweight construction, for

minimal cone breakup and distortion. When paired with the Tractrix

horn-loaded compression driver, it provides speaker efficiency

highest in its class.

NEW TRACTRIX® PORT

Utilizing Tractrix geometry, the new RF-7 III ports allow for the

most efficient air transfer from the cabinet — for the cleanest, most

powerful low frequency response on the market.

DUAL CHAMBERED ENCLOSURE DESIGN

The new bifurcated enclosure allows each 10” driver and port to

work independently from the other. This improves the linearity of

both drive systems, and minimizes standing wave problems inside

the cabinet that can cause frequency anomalies in the sensitive

midrange frequencies.

CAST FRAME WOOFER DESIGN

Each 10” woofer feature a heavy-duty cast aluminum frame for

resonant-free operation. In addition, each woofer incorporates a dual

shorting-ring magnet structure design to eliminate modulation of the

magnetic flux resulting in improved linearity

of cone movement.

FURNITURE GRADE WOOD VENEERS

RF-7 III enclosures all utilize furniture grade wood veneers, and are

available in Black Ash, Cherry & Walnut

SPECIFICATIONS

FREQUENCY RESPONSE 32–25kHz +/– 3dB

POWER HANDLING 250W / 1000W peak

SENSITIVITY 100 dB @ 2.83V / 1M

NOMINAL IMPEDANCE 8 ohms compatible

HIGH FREQUENCY HORN 8.5” square 90˚ x 90˚ Tractrix® Horn

HIGH FREQUENCY DRIVERS 1.75” (4.45cm) titanium diaphragm compression driver

CROSSOVER FREQUENCY 1,300 Hz

LOW FREQUENCY DRIVERS Two 10” (25.4cm) Cerametallic cone woofers

INPUTS Dual binding posts / bi-wire / bi-amp

ENCLOSURE TYPE Dual chambered, bass-reflex — via dual rear-firing

Tractrix ports

HEIGHT 49” (124.5cm) including plinth

WIDTH 13.875” (35.2cm) including plinth

DEPTH 17.875” (45.4cm) including plinth

WEIGHT 97 Ibs (44.1kg