- Precision Motor and Drive Electronics
 - Illuminated Speed Meter
 - Multi-Layered Damped Chassis
 - Power Control
 - Fiber-Optic Illuminated Glass
 - Front Panel
 - Super Mirror Chassis Finish

The McIntosh MT-10 marries classic McIntosh glass front panel cosmetics with serious
mechanics to create a unique, ready-to-play LP solution. With tracking force, anti-skate
and cartridge position preset at the factory the McIntosh MT-10 delivers high performance
LP playback with minimal set up.

The turntable base is comprised of a damped sandwich of stainless steel and acrylic plate;
a unique combination of dissimilar materials that provides a resonance-free foundation
for the tonearm. A massive, 12 pound, 2 ½” thick acrylic platter spins on a cushion of air,
elevated by a custom magnetic bearing.

A regulated power supply drives a super-quiet, brushless, Swiss DC motor. Unmatched
accuracy is derived from a new electronic speed control that references 1,595 strobe
markings per revolution of the platter. Speed adjustments of 331/3, 45, or 78 RPM are
made from the front panel and are registered on a blue, backlit McIntosh meter.

A custom tonearm features a rigid, dural-aluminium arm-tube gimbaled in two sapphire
(horizontal) and two ceramic (vertical) bearings for the least possible friction. A .5mV
moving coil cartridge is included, and features an ebony body with an elliptical stylus.

MCC10 Cartridge Specifications
Output Level 0.5 mV at 5 cm/s
Load Impedance
Greater than 200 Ohms, 500 Ohms recommended
Frequency Response
20Hz to 50,000Hz
Compliance
6 x 10-6 cm/dyne
Recommended Tracking Force 2.4 g
Channel Difference
Less than 0.3 dB
Total Mass 11 g
Stylus
Elliptical Diamond
Cantilever Material
Aluminum
Body
Ebony wood tone

MT10 Tonearm Specifications
Bearing
Sapphire and Ceramic
Arm Tube
Dural-Aluminum
Counterweight
Eccentric
Adjustments
VTA, Antiskate, Azimuth

MT10 Turntable Specifications

Playback Speeds
33-1/3 rpm, 45 rpm and 78rpm
Motor Type
DC Brushless
Speed Control
Electronic w/ braking feature
Platter
Silicon Acrylic
Platter Bearing
Magnetic

MT10 External Power Supply
Specifications
Output Voltage
24 Volts, 625ma
Power Requirement
100 Volts, 50/60Hz at 400ma
110 Volts, 50/60Hz at 400ma
120 Volts, 50/60Hz at 400ma
220 Volts, 50/60Hz at 400ma
230 Volts, 50/60Hz at 400ma
240 Volts, 50/60Hz at 400ma

General Specifications
MT10 Turntable Specifications
Overall Dimensions
Width is 17-1/2 inches (44.45cm)
Height is 8-13/16 inches (22.38cm)
Depth is 21 inches (53.34cm)
Note: Tone Arm Height will vary depending on
type of Cartridge installed

FOR THE Consumer’s Protection
In order to ensure the highest level of customer satisfaction, “new” McIntosh
products may only be purchased over-thecounter or delivered and installed by an
Authorized McIntosh Dealer.
McIntosh products that are purchased over the Internet, by phone or mail order
are presumed to be “used” and do not qualify for any McIntosh Warranty.
McIntosh does not warrant, in any way, products that are purchased from anyone
who is not an Authorized Dealer or products that have had their serial number
altered or defaced.