Details
The Table:
1.25”" thick textured vinyl covered non-resonant MDF chassis.
16" x 11" footprint
19” x 14” x6” overall size
Aluminum Platter
Platter rotates on an oil bath bearing
The bearing has a PEEK thrust disc and machined graphite impregnated brass bushings using a Thompson Engineering 60 Rockwell case hardened shaft.
Tonearm:
New 9” vertical Yoke type tonearm with lateral type bearing.
Pivot to spindle: 223mm
Effective length: 240.7mm
Overhang: 17.7mm
Offset angle: 22.85 degrees
Average RMS distortion: .36%
Damped machined aluminum armtube.
Very pure copper wire, twisted with special insulating jacket.
The armbase is upgradeable to a standard JMW 9 arm.
Additional Specifications:
Type Belt drive (manual turntable)
Motor 600 RPM AC Motor - 2 speed pulley
Turntable Platter Aluminum
Diameter 11.81” (30.0 cm)
Turntable Speeds 33.3 RPM and 45 RPM
Cartridge VPI/Grado Green
Dimensions 18.5” (470 mm) W x 13.5” (343 mm) D x 4.3” (109 mm)H
Weight 12.9 lbs. (5.9 kg)
Cartridge Specifications:
Frequency Response: 10-50
Principal: MI
Channel Separation at 1KHz: 30
Input Load: 47K
Output at 1KHz (5CM/sec.): 5mV
Recommended Tracking Force: 1.5
Stylus Type: Elliptical
Inductance: 45mH
Resistance: 475
Compliance CUs: 20
Stylus Replacement (U=user): U
Additional Information
Does not appear in Skroutz | No |
---|---|
Arm | No |
Dimensions | 18.5” (470 mm) W x 13.5” (343 mm) D x 4.3” (109 mm)H |
Built-in phono preamplifier | No |
Weight (Kg) | 5.9 |