More Views

iFi Audio ZEN Phono

199.00 Price:

On request

SKU:iFiAudioZENPhono
Quick overview:
The ZEN Phono is a wonderful enhancement to your vinyl setup. It will max out every MM/MC cartridge.
€199.00 Price:

Details

LPs + ZEN = Magical combo.

You’ve spent years building your dream LP collection. We know because we have done the same!

The ZEN Phono is a wonderful enhancement to your vinyl setup. It will max out every MM/MC cartridge.

Choc full of AMR/iFi trickle-down vinyl technology, it will have you poring over your LPs into the wee, small hours.

Spec’d to make you smile

Unlike any other entry-level phono stage. The ZEN Phono has:

  • MM/MC from 36dB >72dB gain. Super-silent noise floor -151dBV

  • Precise RIAA with Balanced output, performance comparable to +$1k phono stages 

  • An intelligent sub-sonic filter. Addresses warp without eliminating bass

Hissless whisper

Flagship phono amplifiers create their own power supply off the mains, like a mains regenerator. This is fundamental to a well-designed phono stage. Without this, it will struggle to amplify the signal without added noise. This is why phono stages ‘hiss’ so annoyingly.

Unusually, the ZEN Phono has its own high-tech clean power supply. It creates a 1.2MHz power supply (20,000x mains frequency of 60Hz). In this circuit, a 10uF filtering capacitor = 200,000uF at lower, audible frequencies. With serious levels of noise filtration, it performs at the level of classic LC filtering circuits as found in classic tube amplifiers. On its own ‘island’ PCB, it is isolated so there is no noise pollution of the analogue stage.

Just super clean +/- 12V DC.

Measured EIN (Equivalent Input Noise) is -151dBV. It is 20dBV quieter than some Stereophile Class A+ phonos which are -131dBV.

Mil-spec RIAA

The EQ circuit uses multiple TDK C0G capacitors in parallel. This is for best stability and the least distortion. They beat polystyrene capacitors and are close to Teflon. Read more here

Already using the lowest tolerance capacitors combined with multiples in parallel, tolerance is exponentially improved by the square root of the number of capacitors. This is quite a natty circuit design.

The RIAA EQ tolerance level (+/- 0.15dB) is impressive as it is en par with hand-selected capacitors!

With great circuit comes great components

The ZEN Phono has some seriously good audio components backing up the fab circuit design which has trickled-down from its ultra-fidelity AMR PH-77 and iFi iPhono siblings.

Scroll down for more on the most consequential circuit highlights/boutique components.

Super sub-sonic

The intelligent sub-sonic filter is from the iPhono range and is quite special.

Normal sub-sonic filters remove ‘rumble’ and bass and add phase issues.

Our unique AI phono sub-sonic filter removes ‘rumble’ only

Gain settings

MC (v lo)@

MC (lo)

MC (hi)

MM

72dB (+/- 1dB)

60dB (+/- 1dB)

48dB (+/- 1dB)

36dB (+/- 1dB)

AI Sub-sonic filter

Remedies only the 'warp' in LPs

No negative impact to bass response

Max Output Voltage (RMS)

 

20v RMS bal output into 100k (< 1% THD & N)

13.5V RMS bal output into 600R (< 1% THD & N)

Output Impedance:

BAL

SE

200 Ohm resistive

100 Ohm resistive

Signal/Noise Ratio:

 

94dB(A) MM re 2V BAL/1V UNBAL

80dB(unweighted 80kHz BW) MM re 2V BAL/1V UNBAL

84dB(A) MC Hi re 2V BAL/1V UNBAL

71dB(unweighted 80kHz BW) MM re 2V BAL/1V UNBAL

90dB(A) MC lo re 2V BAL/1V UNBAL

79dB(unweighted 80kHz BW) MC lo re 2V BAL/1V UNBAL

79dB(A) MC vlo re 2V BAL/1V UNBAL

69dB(unweighted 80kHz BW) MC vlo re 2V BAL/1V UNBAL

EIN (equivalent input noise):

0.6nV|/Hz (unweighted) MC lo/vlo

6.5nV|/Hz (unweighted) MM/MC hi

-151dBV (A weighted)

-141dBV (unweighted)

-130dBV (A weighted)

-119dBV (unweighted)

Harmonic Distortion:

 

< -110dB / 0.0003% MM re 2V BAL/1V UNBAL

< -80dB / 0.01% MC lo re 2V BAL/1V UNBAL

< -86dB / 0.005% MC vlo re 2V BAL/1V UNBAL

Dimensions

 

158 x117 x35 mm

6.2" x 4.6" x 1.4"

Power Supply:

 

DC 5V / 500mA

Net weight:

 

515g (1.14 Ibs)

Warranty:

 

24 months

Additional Information

Does not appear in Skroutz No
Signal to Noise Ratio 94dB(A) MM re 2V BAL/1V UNBAL 80dB(unweighted 80kHz BW) MM re 2V BAL/1V UNBAL 84dB(A) MC Hi re 2V BAL/1V UNBAL 71dB(unweighted 80kHz BW) MM re 2V BAL/1V UNBAL 90dB(A) MC lo re 2V BAL/1V UNBAL 79dB(unweighted 80kHz BW) MC lo re 2V BAL/1V UNBAL 79dB(A) MC v
Dimensions 158 x117 x35 mm
Total harmonic distortion (THD%) < -110dB / 0.0003% MM re 2V BAL/1V UNBAL < -80dB / 0.01% MC lo re 2V BAL/1V UNBAL < -86dB / 0.005% MC vlo re 2V BAL/1V UNBAL
In addition AI Sub-sonic filter Remedies only the 'warp' in LPs No negative impact to bass response
USB No
Weight (Kg) 0.6

Reviews

Write Your Own Review

You're reviewing: iFi Audio ZEN Phono

How do you rate this product? *

Quality
0/5
Price
0/5
Value
0/5